I have not got this right from 2011 due to working away and never joining the HPTuners forum. So here I am in need
My combo is a forged 402 from Golen Engines and the topend induction from LME.
2001 Corvette.
I have 11.1 CR.
TFS CNC 235 heads.
FAST 102.
Nick Wilson 102.
LS7 100 MAF.
Meiziere water pump.
KOOKS 1 7/8 x 3" x 3"dual with free flow mufflers.
Cam specs:
Install centre line: 110*
Duration @ 0.50 241/256
Gross Lift: 0.623
Lobe Separation: 114*
I use to run a CL113* D230/236 L0.591/0.601 LS 113* and did a mail order from PCM for less and just used the HPT Pro to load the tune and send back the log for them to calibrate.
It worked and good chop idle nothing to worry about and not knowing better at that point the Vetter ran strong in open loop only and CNC ported stock heads from Golen and no AFR readings happy till I burnt a valve at a topend run 1/2 mile event after wining it a couple of time and use Nitrous it was over...
So went big or go home I thought and at this point I am almost there with my limited knowladge of HPTuners program do have the technical know how and back ground and do all the work at home on the Vette and others as a hobby.
This is one for the pro's as I have been reading for days while work offshore as we speak on hear and the Corvette forum and see there's many guys with the same problem, best thing I could do is to join here thanks to a couple of HPT members that convinced me to do so via the CF.... while looking for answers thank you
I have attached the origenal file from PCM for less and it ran really lean and would not idle at all once at temp.... I also see that the file had the same idle settings and some other than the previous cam with some work done to the VE and Spark tables.
I have done some MAF error and not got to the VE as I don't have a steady state dyno and do my own best with locking the TCC solenoid and in gear on the RPM level 7 4L60. Then from idle to mid range as easy as I can and therefore know the MAF g/sec calc is off but much better than before if you look at the recorded Lamba vs commanded and error display on that I set up as good as I could with demos and calibration success dvds being all the way down in Cape Town South africa
My file to date and a log plus the CFG file.
My email is [email protected] if you need to contact me direct for info and or Q&A.