Running it on the dyno after building our 1st system. I expected some issues and it didn't disappoint It has crazy KR even though I've turned the knock sensors way down and even added some Torco. I'm sure it's not real. It had 10 degrees of retard throughout a good portion of the run. I set the maximum retard at 2* just so I could run it through.
At about 5200 RPM the throttle drops to 64% and the car just craps out. It drops from 500 RWT to 300 RWT in just a few hundred RPM. It feels just like bad plugs or wires but I don't see any evidence of an actual misfire.
Air fuel is reasonably close and doesn't make any huge swings when it craps out. I was thinking I may have fueling issues but that doesn't seem to be it.
In the 2nd log I set Max KR at zero and bumped the timing from 10* to 14*. It did the same thing, although it dropped the throttle sooner and even more than before.
Anyone have any ideas on what to look at ? I'm kind of lost at this point.
Disregard Run file R9. I just can't figure out how to delete it.