Total Masshole.
2013 F150 FX4 Supercrew Ecoboost - STOCK
2013 Mustang GT Premium - Lots of Mods, 424 RWHP SOLD
2009 Cobalt SS/TC Black Sedan
227whp/224wtq Stock. Dejon CP, K&N SRI, Forge BPV, Catless, BadMab Catless DP, MPx 3" Catback, HPT Tuned 328whp/425wtq. SOLD
2004 GTO Pulse Red 1 of 512 - R.I.P. 5/31/09
Yes, if you have Beta installed, delete it.
Then download latest Public release and install
Then download latest Beta and install.
Scanned and uploaded my GT500 last night. Three things worth noting:
1. When I downloaded the tune from the car, there's a new screen that came up asking about what hardware to use. I chose Copperhead not knowing which to use, it seemed to work.
2. Upon uploading the file, the 5.8L engine isn't available in the drop down list.
3. I tried to connect the scanner to the car, and it said it wasn't supported (beta 2.25.223 if I recall correctly) and to use 2.24. Is that correct?
Thanks again to Eric and Bill!
2011 Z07 Carbon Edition
1. Correct, this new window allows reading & writing of specific modules now and means even if our software doesn't recognize the vin or operating system you can designate what pcm or tcm to attempt reading it as, very handy for oddball applications that we don't technically support even though we may support the controller.
2. We Updated the repository drop down lists yesterday and thought we had everything covered but appears we missed this, we'll have it added but no eta as its a low priority.
3. Correct.
It doesn't have to be perfect, it just needs to be done in two weeks...
A wise man once said "google it"
Is there a rev limiter missing in the 5.0 tunes. I seem to be hitting one before the commanded 7400rpm?
I'm so happy. Now I can tune my vette and 5.0. Will get the beta and start playing with my modded 5.0 next week.
This table pops up, I read it it takes like 1 second in this table pops up.
Last edited by 02Ls1; 04-11-2014 at 08:35 PM.
Select Copperhead Ford from the drop down, then hit read
Thanks Erick will do that.
I've read that earlier but I'm exited that didt try it out.
Will the automatic transmission tables in Beta 2.25 work with the ZF in the aussie Falcon?
^ i doubt it, but there was a few torque reduction tables Eric added to a few of the aussie strategies that has hopefully been added to all aussie strategies that are supported.
Can't see the file..
It doesn't have to be perfect, it just needs to be done in two weeks...
A wise man once said "google it"
Why do u still not support the 04 and earlier mustangs? I would love to use both cars on the same softwear instead of using sct for the mustang and hptuners for the camaro!
Erick so i got that validate checksum failed and i email support they say they will be mapping over the next weeks and months
I have to wait weeks for it
Eric, any idea on the trans tables for the Aussie Falcon??