I just tuned my buddies 02 LS sport auto tonight with his new Tuners setup for the Ecotec.
Its gotta stock intake, underdrive pulley, Yank converter. otherwise bone stock.
Got rid of the torque managment, bumped the shift points, dropped the force motor table some for more line PSI, raised the shift pressures slightly and bumped timing about 4 degree's in the high octane advance table and the PE (WOT) timing tables. Got it to see about 25 degrees at WOT, and fattend up the PE for WOT and got the o2 Mv about 900-910 from 850-875 and that seemed to help fattening it up some.
Did most of the usual LS1 tuning tricks to give it some better driveability.
Car seems be over all a little more torquey and a little more healthy above 5K.
As per the owners request i pushed up the shift RPM to 7000 and upped the shift speeds accordingly and it worked, just doesnt pull over 6500....
It seems the timing defaults to a 15.0 degrees above 6400, so that would also explain the flatness that high, not to mention its not meant to make power there. The timing tables only got to 6400 anyway, no more adjustment beyond that
So i moved the shift RPM's back to 6700 and tried it again, better but still so so, finally settled at 6500 34 mph 1-2 and 64 2-3
dropped the force motor table on the low end some more, and raised the shift pressure table another 5 % and gave the car progressivley firmer shifts as more throttle was applied. It shifts like a auto should now.
-Tom