Feedback on Supercharger kit tune please

[amok]

Hi everyone,

I'd love some feedback on this tune. My vehicle info is in my sig. Currently it is stock except for a VCM OTR intake. I have bought the following and will be installing them when I get the tune to a safe initial spot, after that I will start logging and make adjustments accordingly:

Magnuson MP1900 supercharger kit
9 psi pulley
2.5 Bar Map sensor
60lbs Siemens Deka injectors with following stats:
Part # lbs/hr cc/min grams/min PSI BARS
107962 61.85 650 467.6 43.5 3.0

Original tune:
Tune on my car VCM OTR original.hpt

New tune:
Supercharger kit version 2.hpt


Would the above new tune be safe to flash on my car so I can start logging?

[SultanHassanMasTuning]

the not is not setup for any aftermarket map sensor, the OS is stock.

injector data seems strange.

[amok]

Thanks for the feedback

Updated the OP with hopefully better injector data and 2 Bar OS. What do you think?

[amok]

So can anyone please tell me if I'm safe to run the new tune and start logging? Original tune is below too for reference.

Original tune:
Tune on my car VCM OTR original.hpt

New tune:
Supercharger kit version 2.hpt

[amok]

Improved injector curve, I think.

What I'd done originally was from following Greg's Advanced Tuning book "If the new injectors are 90% higher capacity than stock, a multiplier of 1.90 can be applied."

Banish, Greg (2007-04-10). Engine Management: Advance Tuning (Kindle Locations 2880-2881). CarTech Inc.. Kindle Edition.




injector curve.jpg