Boost control

[TJ2000]

How would i go How would i go about tuning my turbo to only build 38PSI? i have a waist gate on that pops about 40PSI and drops me all the way back to 30. I need to maintain 38PSI, My old turbo would ride 38 full throttle. But this one just hits 40PSI drops 30PSI back to 40PSI drops 30PSI.

Thanks in advance, 2005 5.9 with 67/67 tater built turbo.

[Dom_c13b]

go to engine, torque management, turbocharger, and set your min duty cycle up to 70.. start there and see where you're boost is at. You might need to bring it up a bit higher

[Turbo_Mike]

How would i go How would i go about tuning my turbo to only build 38PSI? i have a waist gate on that pops about 40PSI and drops me all the way back to 30. I need to maintain 38PSI, My old turbo would ride 38 full throttle. But this one just hits 40PSI drops 30PSI back to 40PSI drops 30PSI.

Thanks in advance, 2005 5.9 with 67/67 tater built turbo.

We don't seem to have a boost target table yet. Smarty SSR/UDC has it, so it must exist, but as of right now, we can only control WGDC in a manual fashion.
On my 04.5 I just run the WGDC maxed out, but it has a stock turbo and gate. I put a halman pro MBC on my early 04, works great. That's what I'd recommend if you want a certain number accurately.

[TJ2000]

We don't seem to have a boost target table yet. Smarty SSR/UDC has it, so it must exist, but as of right now, we can only control WGDC in a manual fashion.
On my 04.5 I just run the WGDC maxed out, but it has a stock turbo and gate. I put a halman pro MBC on my early 04, works great. That's what I'd recommend if you want a certain number accurately.

ok thank you that is what i was thinking i have a grim speed on order should be here tomorrow.