I am pleased to announce that we've been working on a solution for editing the torque model on Gen 5 ECMs and the latest beta 3.5.055 has this functionality incorporated. If you would like to give it a try, please e-mail support your interface serial number so we can get you setup with the beta.
Our editing concept involves editing multiple tables at the same time (note the link selections checkbox above the tables). This is necessary for a good approximation of the coefficients.
You may notice that each table corresponds to a specific number of degrees of spark timing. You can adjust the resolution of these through controls to the left of the tables, but we've found that using the default setup is sufficient for a good coefficient approximation.
Give it a try and let us know what you think.
VirtualTorque.png