performed swap origninally had a segment swap then repined trans connector and moved pin at tcm. trans did not run correctly.
pcm had no communication to the tcm, tcm had no communication to the pcm. Did and found antoher way to use the 60e tune
and to use a relay. the truck runs now I know the gear ratios have to be changed but I had 2 codes in the tcm now. 1 I know needs to be turned off
p0787 but there is another one that was not stated in the thread I found which was a p2764. Has any one else had that issue. again I know this is old
news but any help would be great.