Hi Guys,
I am new to HPT. Until now we did everything with other, less specific tools. But i bought it for the new Ford EcoBoost 2.3l Engines in the Focus RS.
I'm a bit confused. Today i waned to log a Focus RS.
Unfortunately VCM Scanner only found the normal SAE J1979 PIDs which are less informative.
We already tuned the same car (exactly this car) during winter with another interface and computer without any problems. Knock Retard and so on were available in the scanner.
The car received a Software-Update at the dealership in the meantime.
Does HPT change any code inside these ECUs to send out the data?
If not and if the values are received via "normal" Ford proprietairy protocol, i really cant explain why we cant get them out anymore.
is there any trick? Do i have to license anything special? do some voodoo?


btw: updating to version 3.6 didnt change anything as well as repolling.

heres the info i could get while being connected:

Code:
[Specific Controller]
Ford Tricore 1797, 786400905354, (Ford: 2)


ID: 1359129982
Hardware: 0121
Firmware: 0120
PartNumber: 0000006220
BuildDate: 19.05.2017 00:00:00
InterfaceOnTime: 02:52:35.6500000
ROM: 00 3F 00 81 00 01 00 00 FF
Config: CC 88 00 00 00 40
System Info: F7 00 00 01
Comm Errors: 40 00 00 00 00
SPI Info: 40 15 FF FF 4E 41 00 00
VehicleConnectedTime: 02:52:35.6500000
DetectedProtocols: CAN


SAE J1979 Info: CAN, 500 kb/s

ECM: 7E8, CAN, ECM -EngineControl
VIN: WF05XXGCC5GA87867 - 2016 Ford Focus RS, 2,3 L
Calibration IDs: G1FA-14C204-CL
Calibration VNs: 21C748F2
Basic PIDs: 39
Trouble Codes: 
P0420 - Catalyst System Efficiency Below Threshold (Bank 1) (Permanent)
Scanning Methods: ISO 15031-5 Mode 0x01 Functional, ISO 15031-5 Mode 0x01 Physical, CAN Listener


and a screenshot showing the available parameters

OBD-only.jpg


thanks and best regards

Adrian