Haven?t messed with a Ford in a minute, but worked one buddies 16 GT with 2.9 whipple last week and was SHOCKED that HP tuners doesn?t support many PIDs to actually tune these rigs..
What Gives??
Haven?t messed with a Ford in a minute, but worked one buddies 16 GT with 2.9 whipple last week and was SHOCKED that HP tuners doesn?t support many PIDs to actually tune these rigs..
What Gives??
Email Tunes, [email protected]
96 TA Blown/Stroked, 4L80E/Fab 9
15 C7 A8 H/C 2.3 Blower/PI
14 Gen 5 Viper
Custom Mid Engine chassis, AKA GalBen C
It's just because of the Whipple OS. You're good to go with a standard GT strategy or even Roush strategy
I suppose that makes a lot more sense!! Thanks
Email Tunes, [email protected]
96 TA Blown/Stroked, 4L80E/Fab 9
15 C7 A8 H/C 2.3 Blower/PI
14 Gen 5 Viper
Custom Mid Engine chassis, AKA GalBen C
Actually we support quite a bit on these. You need to use the latest beta, after the initial read, it will prompt you to update the OSID. If you do this, you will have a lot to look at.
If you do not get this prompt with the latest beta, email the .hpt file to support.
Eric Brooks
HP Tuners, LLC
Email Tunes, [email protected]
96 TA Blown/Stroked, 4L80E/Fab 9
15 C7 A8 H/C 2.3 Blower/PI
14 Gen 5 Viper
Custom Mid Engine chassis, AKA GalBen C
Eric what’s your email and I’ll send the file over... I used the lastest 3.7 beta and no luck getting a OSID option when I tired to reread the tune file..
Also for whatever reason 3.7 scanner wouldn’t connect to the car either (but older software would and again limited on PIDs)
Email Tunes, [email protected]
96 TA Blown/Stroked, 4L80E/Fab 9
15 C7 A8 H/C 2.3 Blower/PI
14 Gen 5 Viper
Custom Mid Engine chassis, AKA GalBen C
support at hptuners.com
It doesn't have to be perfect, it just needs to be done in two weeks...
A wise man once said "google it"
Ok! Thanks Bill... send it over today
Email Tunes, [email protected]
96 TA Blown/Stroked, 4L80E/Fab 9
15 C7 A8 H/C 2.3 Blower/PI
14 Gen 5 Viper
Custom Mid Engine chassis, AKA GalBen C