Ive been doing some logging in my car and truck using the recording feature with my mvpi pro but every time I retrieve the files in the scanner, it shows the vin and car I first tuned. Why is that?
Ive been doing some logging in my car and truck using the recording feature with my mvpi pro but every time I retrieve the files in the scanner, it shows the vin and car I first tuned. Why is that?
when you switch vehicles you should write a NEW config to the interface as outlined here https://www.hptuners.com/help/vcm_sc...atalogging.htm
The standalone data logging capability of the MPVI Pro unit allows scanning of the vehicle without the use of a laptop.
To setup the standalone datalogging feature for the first time on a new vehicle or when switching from another vehicle follow the steps below or watch our Standalone Datalogging Demo:
- Key your vehicle into the run position.
- Connect your interface to your vehicle's obd2 port and to your laptop's usb port.
- Open VCM Suite Scanner and open your Table(Primary) Display.
- Click the connect icon.
- Add or delete any PID's you want.
- Save your config for later use(optional).
- Click Scan-MPVI Pro Data Logging.
- Click Write Config-Yes.
- Unplug the USB connector from your laptop.
- Start vehicle if not already running.
- Press and Hold the Record button for ~2 seconds to start recording.
- Press and Hold the Stop button for ~2 seconds when your finished to stop recording.
It doesn't have to be perfect, it just needs to be done in two weeks...
A wise man once said "google it"
Oh, I get it. So I have to write a new config for every vehicle along with the scanner layout I want to use before I use thew stand alone datalogging.