Originally Posted by
ntilley52
No i didnt make any changes to shift speeds on tptd tables, i thought it wouldnt shift until commanded or a max speed or max rpm was hit. In my case i dont care if it ever shifts, only want it to shift with tapped. And so far it is holding gear, it just doesn't respond to taps, it only sees tap when i put shifter into range d5 and have up/down required set to enabled. So it behaves like. D6=Normal drive, when i enter d5, it sees it in d5 on VCM scanner, i then tap either up or down, and the shift mode on VMC scanner says TUTD enabled, It then holds first till rev limiter and never responds to a shift