Woah, I hadn't looked at your tune before when I commented.
You definitely want to fill this table in where the 0's are with some stuff. And the numbers at the bottom are very small/lean. Probably start with filling the whole table with .0153 and lean it out from there? That should get you a requested 12:1 AFR any time you are in power enrich.
powerenrich.jpg
Also, under airflow general tab, it looks like you have mixed data from 2 and 3 bar map sensors?
Take a look under characteristics and pressure ratio. Characteristics look like 2 bar and pressure ratio is 3 bar? What sensor do you have on there?
Again, I'm just learning too, but I feel like that stuff is correct.
Anybody else care to chime in?