I cannot eliminated the delay in power enrichment. Under the power enrichment tab - throttle and delay settings, I have done the following:
-Zeroed the WOT delay time
-Increased the VSS to 128 mph so the WOT delay should be inactive
-Zeroed the TPS Delta Max
-Reduced the RPM delay to zero again disabling the delay above that rpm.
I have also reduced the WOT Pedal Threshold from 3.78V to 3.0V in an effort to have PE start earlier with no affect. The vehicle remains in Closed Loop commanding an AFR of Stoich despite reading 100% load and a MAP reading of 90-100kPa.
This delay can be anywhere from 10-20 seconds, and will occur whether going WOT from a stop or going WOT or increasing to large TPS values at speed.
Am I missing something here? The vehicle is a 2005 Jeep Wrangler 4.0L. Any suggestions are greatly appreciated!