So on this build I am in a 06 with the E40 ECM, LeftCoast 32 4L80e TCM module. I have put in a 2Bar MAP so I think I found the place to change the MAP on Engine-Airflow-General Sensor Linear is 244.68 Linear B is 81.56 Offset is 10.21. Went to new style throttle body so not sure what I need to change for that. I will have to pull my old tune out since I had already done the LS7 MAF card style swap on it. Now for the injectors.....ID1050X......I was reading somewhere on the HPTuners Forum, to double the stoich and half the data I think instead of having to scale everything that was g/sec related etc etc. Then I have to wire in the FlexFuel sensor and start working through that, but at this point will just run 93 in it......I am trying to get it to at least start and idle some want to get oil pressure and check for leaks and sensor feed back and such. I changed the gearing for the transmission already as well since we did a 1/2 cluster swap.
I know to get help I need to post a file. In doing the OS upgrade for the 2bar map, everything should have carried over? I am going to post the prior and after 2bar patch and see if that works.....