Hey guys, I'm having issues getting my gen2 coyote to rev past 7000 rpm. I have the cutoff set at 7800 and the temperature base stuff set at 7800 as well. Can someone take a look at my tune and see what I'm missing? Thanks!
2018manifold.hpt
Hey guys, I'm having issues getting my gen2 coyote to rev past 7000 rpm. I have the cutoff set at 7800 and the temperature base stuff set at 7800 as well. Can someone take a look at my tune and see what I'm missing? Thanks!
2018manifold.hpt
Just got off work I’ll ck it out as soon as I get home
Ok thanks much!!
load this and try it and log it and post log file please
Ok, thanks! I tried that and it was basically the same. Here is the log file, hopefully I logged the correct PIDS.
wot.hpl
try increasing your min and max torque to 650, and cylair wot multiplier to 1.99 and manifold volume to 11.960, also try raising the Max torque table see if any of those help
Ok I'll try those changes. I do have a 2018 manifold on the car, and was under the impression that those were 12.5L?
from there log you sent with my updates it closes throttle at 7140, I did everything I’ve done to prevent this from happening. So I’m scratching my head
no vehicle speed sensor input, ECU thinks it is in neutral. Raise that RPM.
Raise the neutral cut off like Murfie suggested, I didn’t think to change that.Let me know how it goes.
Last edited by Bill88stang; 11-09-2019 at 05:42 AM.
Neutral cutoff fixed it! Thanks guys for the help.
How did it feel I made a few tweaks to the file
No problem glad it felt good