I searched a bit, but figured I may get my answer more quickly here.
This is on a 2007 Trailblazer SS
I have the MPVI pro setup, I plug into the vehicle and connect, I had it setup as I wanted and did the write config.
I went out ran some data into it and when I got back to look at it, my config I had, that was setup this way;
Screenshot (47).png
Mainly, this has a "current gear" in the PID table, which I would like to figure out how to use (I got it before in my Regal no problem) but this cracker is being finicky.
After I run data in the logger that I just wrote the config while hook to the car, I open the log and it is this;
Screenshot (48).png
First thing I notice is gear selector gone, but I haven't compared line by line yet.
Any ideas here? I think I'm pretty sure I am doing it correctly, but........
That or I'm making a mistake in the added gear position?
I can't figure it out.