098.hpt
okay i think ive attached to file correctly (getting the hang of this posting on forum thing)
so disabling the automatic transmission option sets throttle codes and limits rpm to 3500.
ive tried adjusting or even maxing out any limiting values in the tune to get around it with no luck
then leaving the auto function enabled solves the throttle issues and the rpm limits go away. however it runs the cooling fan at 92%
part throttle driving is really good and feels normal. but under load it pegs lean and surges (almost like its starving for fuel)
ive ruled out mechanical issues and there is plenty of fuel system. adjusting the cylair multipliers and torque tables has no effect.
which leads me to believe its not even using those tables and its just using its idling parameters.
also one last bit of info. i seen a few people on this forum with the same issues going from an auto crown vic to manual
on one post eric had chimed in and said theres no way to fully disable the auto logic and that the best thing to do was flash in a manual strategy from a musting.
thanks for your help
any input is appretiated