can someone check this out and give there opinion
can someone check this out and give there opinion
That's just a stock tune. Do you have your revised tune available?
its not a stock tune go look at the change history logs
just have issues with AC it works fine in park but in gear idle is up and down and compressor clutch doesn't kick in until I start moving again
not sure but disable conditions say enable at 4000 rpm disable at 4000
ok across the board or just up to about 900 rpms? and other than that what do u think the rest of the tune looks like
Drop stall saver across the board or just idle areas?
2000 Chevy Silverado Zack Conner Tune 11 Final.hpt
If your Truck is otherwise stock try this file. This is a file i worked on for a while on a 2000 5.3 silverado. All LTFT's are within -1%. Truck drives great and pulls very good.
Nothing it was bone stock. But the stock VE table on those trucks is horrible. This is set for 91 octane, truck drives amazing and shifts perfectly. I have updated the tune and will post tomorrow.
2000 Chevy Silverado Zack Conner Tune 11 Final.hptLS Graph GEN 3.Layout.xml
I have attached the tune and graph setup for you
hi guys newbie trying to learn some of this tuning jargon i have a 1999 silverado with a 5.3 and i have put the summit stage 1 drop in truck cam 8712 ,changed intake to bread box style off a 2007 tahoe with the injectors and i also put one of the g 92mm throttle bodies with my stock tps and iac on it as they seem to work better, also using the 07 map sensor iv been watching goat rope and chopperdoc and reading pages and pages on forums but just cant figure out what needs attention it lacks power from take off and doesn't down shift at all at higher gears just bogs down if anyone could please help as im a old school carb guy and i feel as this is Chinese arithmetic lol ,thanks in advance run2.hpl