This tune and scan file is from a 2008 Silverado with a single turbo. I had it on the dyno and could not keep it from pulling the throttle back at 98 mph and 4,100 rpm. In third gear. If I kept it on the floor it will give the throttle back at 95 mph. The ETC torque management says axle when it is limiting the throttle. I did everything I know to do to get rid of this. I increased all the torque management for all the axles, increased all the limiters and cutoff I could find. Nothing would fix it. It does not do this in second gear. I am thinking there must be a table that I don't have access to. I was hoping someone on here might have run into this before and might be able to help me out. I searched the forums when I had the truck tied to the dyno but could not find any answers. Thanks for looking.10-17-20.hptdyno pull axle torque.hpl