I went a little more aggressive on the FF table and it does appear to be working. Thanks again!
I went a little more aggressive on the FF table and it does appear to be working. Thanks again!
I'm trying to find the pinout for a 2005 Grand Prix...my friend swapped the engine from one into something, and last night when I went to his shop to disable VATS and get it firing for him, I found it was an E40 with flex fuel enabled...but it's also a VIN/OS mismatch...something funky going on, but I'm still looking for this pin.
I'll post it when I have it.
Last edited by MikeOD; 07-14-2015 at 07:44 AM.
2010 Camaro SS M6. Stock Bottom End, Heads/Cam/Intake/Headers/Exhaust.
2005 Silverado RCSB. Forged 370 LQ9/Borg-Forced Inductions T6 S484/Jake's Stage 4 4L80E with D3 Brake/4WD.
2023 Durango Hellcat
I already looked into that, I believe they used a Virtual setup though, and I couldn't find anything in the diagrams for it.
www.crawford-racing.com
Home of the original and best selling CR-Fueler plug and play port injection controller kits for all GM Gen V direct injection platforms.
Did anyone get the Flex Fuel to work with P59, F-body, 2004 GTO file with 12587604? Getting O2 heater DTCs and FF alcohol content is not working.
P59_Flex_Tune.hpt
Last edited by TedKt; 11-02-2020 at 06:55 AM.
2002 Camaro LS1 N/A, Moderately Built 4L60e, Yank 3200, Wiseco pistons & rings, Compstar rods, 230/237-.625/.625-111 cam, ported stock 241 heads, 92/92 FAST intake, Pacesetter LT, SE True Duals, 25% underdrive pulley, SLP lid, 60# injectors, Flex Fuel, 160 T-stat, lcas, pan hard bar, sub-frame connectors, torque arm relocation, Dana S60 4.10, KYBs, Strange DS, Walbro 450.