-
Tuner in Training
Can I tune my Hemi install with HPTuners software?
I have a 2007 Jeep Wrangler JKUR. I have installed a 2010 Ram truck engine/trans in it.
The computer was tuned by Jeep Speed Shop and the Jeep has lots of power but has some poor driving characteristics.
With the cruse control on, I start up a hill and the thing will down shift 2 gears instead of one. It also get a lot lower fuel mileage than I think it should.
Anyway, do you think this software will tune it?
I have no experience with tuning so I will be asking a lot of questions, if I purchase it.
Thanks for any help.
-
Tuner in Training
Is there anybody on here that could guess at whether HP Tuners software will read my jeeps PCM?
-
Potential Tuner
Welcome to the JSS club of .. "Not having any real information on what Todd did to the ECM". I messaged him a couple days ago and he finally responded with "I only do a little Diablo tune, otherwise it's stock".
-
Potential Tuner
Yes the HP Tuner software will read your ECM. I think the newer model JK's 15+ have to be sent in and modified by HPTuner before you can flash to them. I would check their main website and see compatibility.
-
Advanced Tuner
So, are you running the Dodge PCM or the Jeep one?
Either way I think you are able to tune, but to what extent I have no clue
https://www.hptuners.com/products/vcmsuite_vehicles.php
Digging around in here will give you more information though
https://www.hptuners.com/forum/forum...ing-Engine-Gas
If you ask around in there they should be able to tell you what limitations HPtuners has with that platform.
-
Potential Tuner
Did you ever get tuning modified on yours? I am looking for some drive ability smoothing myself. I have a 08 Jeep Wrangler JK with a 2014 Hemi VVT 5.7 and a 545RFE trans. The conversion was done by Jeep Speed Shop and I bought this used recently. The ECM is a NGC4.