Hello all, I've scowered the Diesel section for PS for any sort of beginners guide but have found nothing so far. I'm New to Diesel, Not to tuning. I'm not a shop just tune my own stuff. I Did basic stuff on my Coyote with HPT and My old Cobalt SS/SC with HPT as well. But with Diesel this is completely new. I have a 2013 F250 4x4 with 95k miles. Completely stock currently. I've done a bit of logging and inspected the Factory file. So I have familiarized my self. I'm not looking for a hand holding session. But just some basic advice. Things, Like How do I scale MAF if i go to a different intake, adjusting injection timing or injection quantity. I have the calculator spreadsheet. But I don't know the correct way of using. Like how much is too much injection timing? To me these are sorta basic things. I don't have a dyno to access either. I'm also not here looking to make max power on a stock truck. Just things to make it overall better. Any advice is greatly Appreciated. I have stock read I can throw up and long data loggin sessions. I also am unsure of what histograms I should create. I have a injection timing, VGT Position and boost pressure minus atmo setup currently. Thanks