So Ive been fighting this rail pressure correction for a couple days now and I cant seem to figure out how it works. It started with stock correction tables and it was not following the pressure commanded in the tables. Should be 130mpa it was showing 150mpa in the log. Ive tried zeroing the multiplier tables for ECT in 100-225F and 170-180f in the IAT and it wouldnt exceed 50mpa. Ive tried zeroing the adder tables for ECT and IAT and same result no more than 50mpa. Ive tried putting 1 in all the tables. Ive tried 1 in the multiplier, and stock in the adder, tried stock in the adder, 1 in the multiplier. Ive tried 5 in the multiplier tables with 1 in the ECT adder and stock in the IAT adder (no more than 69mpa).
I also might add that when the correction is giving me problems it is also riding on the boost limiter and I was told there may be a hidden table that is adding rail pressure. I do not know where else to go it does not seem to make any sense to me.
Also when I use the stock correction tables I can view whats in the tables and it seems to add up. For example in one area it supposed to be 150mpa (see image Attachment 122544) and in log it shows 169mpa (Attachment 122543) and in the correction table for 190F ECT and 40F IAT it shows 1.3 in the correction and shows 15mpa in the 2900/90mm3 range (see picture Attachment 122545) 1.3x15+150=169mpa.
IMG_7320.JPGIMG_7319.JPGIMG_7318.JPGIMG_7317.JPG