03 ls 4.8 turbo build. car ran fine before tune. changed operating system to 2 bar SD tune and now i have no throttle. DBW. please tell me how to fix. car idles good but zero throttle response.8-22-22 changed map characteristics.hpt
03 ls 4.8 turbo build. car ran fine before tune. changed operating system to 2 bar SD tune and now i have no throttle. DBW. please tell me how to fix. car idles good but zero throttle response.8-22-22 changed map characteristics.hpt
Last edited by Turboz280467; 08-22-2022 at 07:52 AM. Reason: added tune
Silly question but you do have a 2 bar MAP right?
yes sir
Did you fix the VE table after applying the 2 bar OS?
Tuner at PCMofnc.com
Email tuning!!!, Mail order, Dyno tuning, Performance Parts, Electric Fan Kits, 4l80e swap harnesses, 6l80 -> 4l80e conversion harnesses, Installs
What MAP sensor uses 200/10.33?
"DBW" but in System Options ETC = 0?
As long as you have a PCM that has the transistor drivers
tried that. when key is cycled it sounds like it calibrating and then nothing.
Did you apply the 2 bar OS to the same file the car ran fine on or some other random file?
More importantly, how long has it had this problem? Because it sounds like it's been longer than the 1.5 years since that last post. The changelogs in the file go back to 2017, and they are all ETC=0 too.
Just to be super clear: ETC is electronic throttle, DBW is electronic. DBC is a physical cable, a wire (no, not that kind of wire, the kind like a bicycle brake cable) that connects the throttle pedal to an arm on the outside of the throttle body.
What is the platform? What's been changed? If it's a swap vehicle what was the donor? Was it originally DBW or DBC?
yes same file. and by running fine i mean it will idle good.
yes its had this problem for a while. i changed gears on the build and had to re-do the frame and floors and now im back at the motor. when i initially did the swap the car ran great, but with the turbo installed it was very lean. i purchased HP tuners changed injectors and started a tune with changing the operating system and vats and a couple other things. i have switched the ETC to 1 instead of zero. when key is turned on you can hear the throttle blade calibrate but when pressing the pedal nothing happens. doesnt even register on the vcm scanner.
Has the throttle ever worked with this combo of parts?
edit: And since the tune was messed with the first time?
yes before the tune i drove the car with these parts. but since tune it hasnt worked.
You wouldn't happen to still have the very first tune file you pulled out of it before you started, by any chance?
Did some more digging and comparing. The oldest entry in the changelog is not stock, so it was changed sometime before that log started in 2017. There's so much nonsense changed in the current file over so many revisions, stuff that was changed apparently even after the throttle stopped working, I'm not going to look at this again until you can get a stock file flashed back into the thing.