VCM editor says it reads vehicle but sits stuck on "read complete" If I select hardware (2 choices either fail) but if i leave field blank it says "skipped" and continues that's when it says read complete and doesn't load tune like it should. Gathering info or read does give me make/model info and vin.
VCM scanner detects vehicle, displays it on top (correct veh info) and that's it. wont log data. Doesn't seem to be actually connected. At some point in all this when reading if I select specific hardware it fails and says "protocol not detected"
Is my ecu just not supported? Did I waste another 50 dollars hoping to avoid the dealership? I just want the trans failure to go away and the bike to shift without going limp.