Results 1 to 10 of 10

Thread: 2010 camaro wont startafter drive into work Help

  1. 09-08-2023 #1
    SFR7771
    SFR7771 is offline
    Tuner in Training
    Join Date
    Feb 2022
    Posts
    12

    Angry 2010 camaro wont startafter drive into work Help

    First, I checked fuses, battery and its new, relays not getting any clicking on them, everything and I have a new ECM with vats disabled. Changed my tune last night and only changed my MAP sensor to the correct setting. This is a new ECM after locking up my other several weeks ago! On my way to work was running VCM scanner when I parked VCM stopped scanning and the VCM software diapered (went off) on its own. Reloaded a later vers of tune and still nothing all light come on dash and go away before starting the car but won't start. Also, when I try to re-sync it says re-sync failed name revolution failed?
    Last edited by SFR7771; 09-08-2023 at 03:25 PM.
    Reply With Quote Reply With Quote
  2. 09-08-2023 #2
    STAGEUP
    STAGEUP is offline
    Advanced Tuner
    Join Date
    Aug 2006
    Location
    Arizona
    Posts
    268
    Post log, tune, and mod list
    2009.5 PBM G8 GXP M6 W/Roof-Self tune, OBX LTs, Kooks axleback, LSA blower, cam,
    Monster LT1-SC clutch, flex fuel, 12 psi [email protected] 1,800 D.A
    2007 TBSS-Self tune, bolt ons [email protected], 1,900 D.A
    1991 GMC Syclone- Self tune/catback 12.8@104, 4,200ft D.A
    Reply With Quote Reply With Quote
  3. 09-09-2023 #3
    edcmat-l1
    edcmat-l1 is offline
    Senior Tuner edcmat-l1's Avatar
    Join Date
    Aug 2006
    Location
    5BA8
    Posts
    3,525
    SMH and code list too!!

    EFI specialist
    Advanced diagnostics, tuning, emissions
    HPtuners dealer and tech support
    email=[email protected]
    Reply With Quote Reply With Quote
  4. 09-09-2023 #4
    SFR7771
    SFR7771 is offline
    Tuner in Training
    Join Date
    Feb 2022
    Posts
    12
    So I got a key not detected error code after I did a write entire and then the car start so not totally sure what happened. I?ll post tune tomorrow. I just got my pass word reset! SMH
    Reply With Quote Reply With Quote
  5. 09-09-2023 #5
    SFR7771
    SFR7771 is offline
    Tuner in Training
    Join Date
    Feb 2022
    Posts
    12
    Sorry for the delay it was stressful to say the least. I need to do a key re learn but not sure how to get it done but I think it?s not safe to keep running it.
    Reply With Quote Reply With Quote
  6. 09-12-2023 #6
    SFR7771
    SFR7771 is offline
    Tuner in Training
    Join Date
    Feb 2022
    Posts
    12
    2010 2SS/RS/ Mods, Whipple, 1000cc injector, 102MM TB, Innovation West 10% OD pulley set up 8 rib, AGP twin 450 fuel system w flex on E85, CAI K&N, LT with OR Cats aka no catalytic converters, Coils and wires, 3" exhaust with mufflers, Oil catch can, 2015 ZL1 9.9 3.23 ratio, BMR upper Lower control arms, 15"conversion, BMR Anti Roll Bar 315/60/15 ET street slicks
    Reply With Quote Reply With Quote
  7. 09-12-2023 #7
    SFR7771
    SFR7771 is offline
    Tuner in Training
    Join Date
    Feb 2022
    Posts
    12
    db tune 9.hpt

    Tune attached
    Reply With Quote Reply With Quote
  8. 09-12-2023 #8
    SFR7771
    SFR7771 is offline
    Tuner in Training
    Join Date
    Feb 2022
    Posts
    12
    Code I pulled with snap on scanner P0633 immobilized key not programmed, Also note I did a write entire of my tune and it started.
    Reply With Quote Reply With Quote
  9. 09-12-2023 #9
    SFR7771
    SFR7771 is offline
    Tuner in Training
    Join Date
    Feb 2022
    Posts
    12
    Code I pulled with snap on scanner P0633 immobilized key not programmed, Also note I did a write entire of my tune and it started.
    Reply With Quote Reply With Quote
  10. 09-12-2023 #10
    SFR7771
    SFR7771 is offline
    Tuner in Training
    Join Date
    Feb 2022
    Posts
    12
    this post is what happened https://forum.hptuners.com/showthrea...still-no-start
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »