Dyno tuned a general 1000 today and had decent results. Gained up to 9hp at one rpm point, averaged somewhere around 5hp from the mid range and up. Pretty happy with the results but i believe there is more to be had throughout the curve if one could measure accurately. Tuning was done on a MD500se-xl 2wd from mustang dynamometer.
what did you change?
Great gains! Not much more in there though.
Basically just did some shaping on the timing table and remapped wot fueling slightly.
im trying to figure out to graph VE did you use desired lambda for the fuel command pid?Originally Posted by 04silverado6.0
Should be desired lambda. I didnt do any ve tuning on this one but i had a rzr 900 that required ve tuning.
Reply With Quote