Could there be a reason of why MPVI3 cant read my Ford PIU?
See image.
not reading.PNG
Could there be a reason of why MPVI3 cant read my Ford PIU?
See image.
not reading.PNG
Have you re synced your interface? It will check for updates and add as needed.
I had to do it so my MPVI2 could read my 2020 Explorer.2023-11-15 08_16_09-.png
Is there anything in the drop down box to select next to hardware?
I have re synch already, but still no luck
Yes, there are a bunch of options. not sure which to pick
IMG_4436.jpg
IMG_4437.jpg
IMG_4438.jpg
The only one that seems that It wants to read is the one that says ESYS 2048K FORD, I dont let it finish and I abort the read, I not sure if that would brick my ECU.
ESYS is correct, you wont brick anything by reading
Newer MAP based Cyclones runs on TC-1791
Last edited by veeefour; 11-16-2023 at 08:08 AM.
v-performance.pl/
facebook.com/veee.performance/
https://www.instagram.com/v.performance.pl/
Remote tuning:
[email protected]
+48 697276579
It reads the file and saves it but cant open it. Following messages pop up right after. Already sent the VCM Suit log file to support.
IMG_4445.jpg
IMG_4446.jpg
IMG_4444.jpg
Got it to work by using the VCM suite BETA