prolink+ 0-5v sensor

[poulina]

I am trying to setup a fuel pressure and oil pressure gauge through the two prolink analog inputs, using 0-5v, 0-100psi transducers.

If I am understanding this correctly;

Connect signal wires from transducers to prolink
Connect ground wires from transducers to prolink
Connect 12v (ignition on) to transducers
Following the hpt directions for transforming voltage into sensor data.

I dont like doing wiring twice so just wanted to nail down a procedure before attempting, so any tips would be helpful. Thanks

[blindsquirrel]

Your transducers are designed for 12V in and 5V out?

[poulina]

ahh no lol. Where would I get 5v from to send to the sensor?

[blindsquirrel]

Any of the 5V wires already going to any of the original 3-wire sensors on the vehicle?

[poulina]

roger thanks