Hey guys,
Recently picked up a 2015 A3 2.0T as a small project, it came with an MPI kit (CTS) already installed. Looking into getting it activated on now.
I found a thread on here where someone enabled MPI on another Simos18 ECU, compared out their changes and had a few questions if anyone could help that'd be awesome.
The following maps are not present on the 259D ECU definition:
Fuel - General - MPI - "Inhibit Table 0" set (Not present on 259D file)
Inhibit 11 & 12 to 0
Fuel - General - MPI - Valve Diagnostic - "Manual Inhibition" set to (Not present on 259D file)
0
Fuel - General - MPI - Valve Diagnostic - "Diag Init" set to (Not present on 259D file)
Whole table to 16
Any hints you may have are much appreciated! Attached is the OEM virtual read of the ECU.