My Scanner is reading 0 on my exhaust cam angle. I thought maybe something was up with my sensor or the PCM. I went back to an old log where it read 125 and that old log is now showing 0.
Any ideas on how to address this?
My Scanner is reading 0 on my exhaust cam angle. I thought maybe something was up with my sensor or the PCM. I went back to an old log where it read 125 and that old log is now showing 0.
Any ideas on how to address this?
with a JPEC2 controller the parameter to log is 'exhaust cam center position'
with the JPEC2a look for 'exhaust cam angle'
If anyone runs into this it was a bad PCM.
oh wow really?
can ya post the log and the tune?