I've got a 05 Silverado 5.3 swapped with a 6.0. It has a cam in that I know nothing about. I didn't build the engine and I don't know the guy that did. It's pretty mild because it started up fine and idled with little issues. Anyway I roughed in the VE Table first using NB. I've stayed out of PE until I get a WB on it later this week. Today I wanted to get the MAF started then when it was done put a WB on and finish both tables out completely. I made quite a few changes to the VE Table but the MAF was pretty much within 2% for all I could reach without getting into PE. I know being a mild cam the changes won't be as drastic, but just want to make sure I'm not missing something. I went back to check my settings and didn't see anything. I know I've got some timing/KS issues. I'm not ignoring it just haven't sorted it out yet.