While you're waiting set displacement to zero and maybe try again.
Do you know anyone who has a WiTech module? There are other causes for the error you are receiving. Did you happen to disconnect the steering for any reason (header install?).
Specializing in building and tuning 1000hp, daily driven, 9 second cars!
www.ostdyno.com Shop Phone: 724-368-9000
Unfortunately i don't. The steering wheel was not disconnected. All we did was put a Whipple on it.
I have a Snap On J2534 PassThru but I don't think it will do the same things as the WiTech
Just to update this I was never able to figure this out. I never heard back from support. I ended up having to tune it on the street w/ WB02 obviously and the car runs great.
None of this makes any sense and after a certain point I really didn't care. I spent way too much time on this job and lost my ass. Yes I would have liked to know what the problem was but at the end of the day, the tune up is safe, car runs great. On to the next one.
Just wanted to mention if anyone comes across this thread, I was able to successfully dyno a 2022 Challenger AWD on our RWD Mainline dyno. After doing some research on how the transfer case works (see link below) I decided to just treat it like a GTR or R8/Huracan and removed the FWD shaft and then just ran it on the dyno until ABS faulted out and it was perfectly fine.
https://www.borgwarner.com/newsroom/...YkilrpFPc_MJds