HOW TO: Setup AFR / Lambda ERROR Graphs vs. VE Table (non Virtual VE Vehicles)

[DGS]

So what tables would I need to set up for a newer vehicle with Virtual VE tables utilizing MAP/BARO pressure ratio on y-axis and RPM on the x-axis? Here is my log and tables. Why do I richen tune when I use paste special - 1/2? Is there a different formula I should be using due to the MAP/BARO ratio table values that I am changing? My log is open loop with EVAP purge unplugged. When I upload a log, does it include the tables/graphs I have made or do I need to somehow upload them also? This is fairly new to me. Thanks for the help.

[DGS]

You would set up a chart with rpm on y and use pressure ratio selection under math at the bottom of list for x. Then log your map, baro, and a/c pressure in your parameter list. Make sure the scales match the VE table. Once your logging, the data will log if all the settings match.

[DGS]

I have other posts under VE showing my parameters and graphs.

[asquinton]

schpenxel,

Thanks very much for your post, it was very informative. I've went through this in a/f ratio error and have had no problems. When I used the same process on EQ errror I get nothing in the tables. I used EQ Err under maths with no luck. I don't see user defined maths any more either. Does anyone have any ideas. I'm running the 2 bar OS system and cannot get data under power enrich without it. Thanks!!

Aaron

[Drivinsidewayz86]

Any chance anyone can help me with this table, I've done exactly what the original post stated but no values are showing up in the graph

[charcoal03silvy]

Any chance anyone can help me with this table, I've done exactly what the original post stated but no values are showing up in the graph

You're going to need to post up how you have it set up and what channels you're logging if you want help.

[Drivinsidewayz86]

I was able to figure it out using the how to on here , now I just have to scale my map correctly .