Transmission parameters 65RFE with Scanner

[10le]

Hoy together

In my scanner I can not load or activated the parameters for my tranny.

For me important would be like active status and input/output shaft speed.

What did I wrong? Enginen parameters are all fine.



Servus
10le

[LilSick]

connect to the car and repoll and see what is there

not much for that trans

output shaft speed is there tho

make sure you save

[10le]

Thank you. In the past I did defined the channels offline and I could see in a HP Tuner vid on Youtube that it is better to define the channels connected to the car. I will try and hopefully be lucky with this.

Short question, if you want to answer: how can I add the empty rows in the scanner? only asking for a better overview during test driving.

Servus
10le

[10le]

HOy

Did realise your recommendation and still not succesfull. But could find some, which were not working. Thank you for that.

Servus
10le

[10le]

Question:

Could a faulty Gateway module influence the access to the tranny parameters for scanning?