Help reducing TM - 07 Silverado 6.0L

[marcuslf]

I have a NBS 07 Silverado, with the 6 liter VortecMax. I'm trying to either eliminate or reduce torque management at WOT. Attached is my config attempt, and a log. If you look at the log, looks like there's still a significant timing advance drop, and drop in torque output (~30%) during the 1-2 shift.

I've changed everything I can find/know how to change....is there another param I'm missing somewhere?

For this truck, some of the options that I've seen mentioned don't seem to be available...unless I'm overlooking them somewhere, like disabling Abuse mode, shortening shift times, etc. All that I was able to find was shift pressure settings, and torque reduction settings.

[2xLS1]

Look in the Transmission>Torque Management tab. There are a lot of TM tables there to adjust or zero out.

[marcuslf]

I only see 5 tables there:

Torque reduction Normal - I changed all values for 1-2 shift to either 0 or 5%
Torque reduction Performance - ditto
Torque reduction Downshift - didn't change anything here

Abuse Mode Torque reduction: I didn't make changes here. The default value is 100% reduction from 2048 rpms and up....I don't think I'm hitting 100% reduction
Abuse ModeReduction duration: Didn't make any changes. The X axis is Transmission Oil Temp. Y axis doesn't have a label. Almost all values are 0.6 for normal ranges.


So....should I really be zeroing out these last two tables? Doesn't seem like they're being activated - doesn't seem like it would matter.

The only other options on the Transmission TM tab are:
General
- Diff scor (default disabled)
Stall Torque Mgmt
- Enable RPM (2000 rpm)
- Disable RPM (1600 rpm)
TCC Limit
- Tq Reduction (disabled)
- Max Torque (6045 ft lb)

[EC_Tune]

Abuse mode is when you are "brake torquing" the engine. FYI

[gman4dx266]

..."brake torquing" the engine...

*drools*

"...Whats that smell?"