P59 And Boost

[1TANK]

I've seen a bunch of threads about the the P59 with 2/3 bar OS and the reduced resolution in the VE table. Question is : If you had a good running vehicle with a P59 and wanted boost, would it stop you from doing the boost addition or is it not really an issue? My vehicle is not a daily driver, but I like it to drive good. It currently idles around 55kpa- 6.0 engine with BTR TN cam.

[gametech]

Not an issue. Untold thousands of vehicles are forced induction with a p59 computer.

[SkinnyG]

+1

I am running 2-bar P59, LQ4 (stock cam), 7875, 4L80.

I have absolutely zero complaints about daily driving it with the reduced resolution. If your VE table is reasonably smooth, it is no problem at all.

[1TANK]

Thank you both, I will proceed with ordering part$ !

[RDF1]

Its not that big of a deal. The main thing is if you want it close to perfect as possible filter out all the data between the axis scales.
So if you have a MAP axis if 110 130 150.
Then make sure to filter out all the data except a few numbers above/below the axis numbers. Its time consuming but atleast it will be the best you can make it.