Does anyone know if the signal expected is;
0 volts = 0% ethanol
1 volt = 20% ethanol
2 volts = 40% ethanol
3 volts = 60% ethanol
4 volts = 80% ethanol
Does anyone know if the signal expected is;
0 volts = 0% ethanol
1 volt = 20% ethanol
2 volts = 40% ethanol
3 volts = 60% ethanol
4 volts = 80% ethanol
Last edited by stingray22; 1 Week Ago at 02:37 AM. Reason: typed the same msg twice
Just tested pin 6 and found it had 12 volts on it. Also the wire on pin6 runs across to pin 20 on the fuel pump power control module.
So I don?t think this is right.
Reply With Quote