Results 1 to 3 of 3

Thread: 08 Envoy Base Tune and Log Review

  1. #1
    Potential Tuner
    Join Date
    Jun 2025
    Location
    New Jersey, USA
    Posts
    5

    08 Envoy Base Tune and Log Review

    Submitting for review by the group.
    08 Envoy 5.3
    4l60e, 3.73 lsd
    CAI, dump after factory y-pipe.

    Base tune with DOD turned off, torque management lowered, spark retard limited, idle increased.

    Log is a short drive, wot off idle through 1st gear into 2nd, let off after the shift.

    Looking for input. Does anyone see anything glaringly wrong, or areas to improve?
    Thanks in advance!

    Envoy Base Tune.hptEnvoy Base Tune Log 1.hpl

  2. #2
    Potential Tuner
    Join Date
    Jun 2025
    Location
    New Jersey, USA
    Posts
    5
    From 1st glance, there's a big gap between pedal position and throttle position. At the top of the WOT pull, pedal shows 99% while throttle is only 83%. Idk if that's normal or not.
    Also, the commanded afr is quite rich at 11.24 (taken from the same point as the other readings for throttle), so I'm sure there's room to bring in some spark.

    I'm open to all input, criticism, etc.

  3. #3
    Tuner Alex14SS's Avatar
    Join Date
    Aug 2021
    Location
    Florida
    Posts
    170
    Remove Burst Knock completetly and remove torque management out as well completely
    all torque management needs to be 6041 at cap and make your [ECM] 32981 ETC Tip-in Rate Limit 100%
    Disabled Brake torque management and max it out.
    Max torque in TCM Method can be at 6041 if you want to have the TCS not kill so much power as well only when spinning.
    EQ Ratio Based [ECM] 32447 you can make it 20% more all across by doing 1.2 then press multiply X Symbol
    Power enrich make it 40% Across and remove those stupid delays lol
    enrich rate make it 2 and 2 thats just my prefrence tho
    then in Knock recovery you can make 2k + Rpms say 1.5 in recovery rate instead of 0.055

    Remove Burst Knock completetly and remove torque management out as well completely
    all torque management needs to be 6041 at cap and make your [ECM] 32981 ETC Tip-in Rate Limit 100%
    Disabled Brake torque management and max it out.
    Max torque in TCM Method can be at 6041 if you want to have the TCS not kill so much power as well only when spinning.
    EQ Ratio Based [ECM] 32447 you can make it 20% more all across by doing 1.2 then press multiply X Symbol
    Power enrich make it 40% Across and remove those stupid delays lol
    enrich rate make it 2 and 2 thats just my prefrence tho
    then in Knock recovery you can make 2k + Rpms say 1.5 in recovery rate instead of 0.055

    then this should be pretty solid

    Buy tunes here! GM DODGE FORD > https://tunedbyroleari.sell.app/
    Follow me on Instagram > https://www.instagram.com/alexchutini/