IM Monitors won't set after very simple tune

[Formula355]

Hi, I have been having a bear of a time getting monitors to set across the board lately.. I thought this one was an easy in and out, but no matter what we do it wont set the catalyst and evap monitors. There is literally a few hundred miles on the car and still no change. Yes, the fuel tank has been between 1/4 & 3/4. Yes we did 55 for more than 3 mins.

Here is the rundown of the car:
10 Camaro V6 Manual
Cold air kit
Magnaflow cats
Borla exhaust

Made a few small changes to PE and a few other things. Thought all was good until we tried to get the car through inspection.
Anyone have any ideas?
I attached the stock file as well as mine

Thanks in advance for the help.

[Tom @ Overdrive]

You need to turn the cat dtc's back on.

[Formula355]

Will this affect the evap monitor setting situation?

[Tom @ Overdrive]

Should sort them right out. Some monitors wont run without a different one satisfied first.

[Formula355]

I was hoping there was a better setting than deactivate for the magnaflow units.