No start condition with VE tuning.

[drjaredshelton]

I'm adding a turbo and want to tune in the VE mode and eliminate the MAF. Truck ran fine with the MAF plugged in. Now it won't start at all after removing MAF. Tries to fire occasionally, but really just cranks over.

I've added a IAT sensor and deleted the stock MAF.
Added my 2 bar sensor and updated the file to support the right tables.
Extrapolated the data from 105-210 to fill in the new VE table.
MAP sensor has the right calibration.
Write all to the truck for the new changes.
I've made all the necessary changes in the tune to put it into VE mode (ie change the Dx MAF fail, make sure all the settings disable the MAF,

I just don't know what to change in which direction to start. I've swung it both up and down 5-25% in the VE table with no change. Any advise on where to begin to get it to fire up would be great.


Its a 2003 4.8L from a Tahoe swapped into a 1954 International truck.
Mods: Ported 243s, Sloppy stage II cam, headers to turbo, WB

Current file attached. 54International 2 bar turbo VE tune.hpt

[twenglish1]

Record a log of trying to start it. Might not be getting enough idle air, what throttle body are you using?

[nanygoat]

dont forget to match your high octane and low octane in you spark tables

[nanygoat]

also to get it started in your base running air flow make everything 140 and up 14 and it should start

[nanygoat]

140 degrees and up

[nanygoat]

you VE table only shows a 1 bar sensor it should go from 0-201 kpa

[edcmat-l1]

First question should be, since this is a swap vehicle, has it EVER run? Did it run prior to you doing the 2 bar conversion?

[drjaredshelton]

you VE table only shows a 1 bar sensor it should go from 0-201 kpa

The Main VE table goes to 210. The start up VE only has up to 105. It didn't change with the file conversion and I couldn't find any info on if this matters or not. It wasn't discussed in any of the five videos on VE starting.

For the base running airflow, we are talking the ECT vs Idle airflow in P/N and gear?

And I did the low to high octane spark tables first with all the other changes.

Yes, this truck has been running for about two years with the 1bar sensor and MAF. I'm adding a turbo to the build and was advised to do VE instead of MAF for better tuning and throttle response. If I put the MAF back on it, it will run. Currently it is running the older style stock DBW throttle body. I've got a newer stock LS3 style with a different intake to put on it, but wanted to get it running first so I'm only doing one thing at a time.

It does act like it isn't getting enough air to me as well. I just don't know how to tune the DBW to add more air with all the extra tables and such. I'm confidant with cable throttlebodies, but this DBW is new to me.

[drjaredshelton]

Couple logs of trying to start it


25-07-15 11-47-58.hpl25-07-15 11-47-13.hpl25-07-15 11-41-55.hpl

[Alvin]

It's coming down to 9 volts trying to start. This is likely at least part of the problem.

[drjaredshelton]

I just saw that. I'll look into it. Could have been I was cranking it for too long. I'll put a booster on it and see if that changes.