If you put "0" for target RPM in the tables, does that
work like other things as an "ignore" and then maybe
just run off airflow targets alone? Or is this a recipe
for crank-n-die?
If you put "0" for target RPM in the tables, does that
work like other things as an "ignore" and then maybe
just run off airflow targets alone? Or is this a recipe
for crank-n-die?
Never tried it, but sounds like a "crank-n-die" since the correction tables will try to keep it at that RPM. Any reason why you are trying to defeat Idle RPM Control?
It will still run if you command it in RTT, as far as cranking, I am not too sure.
Sulski Performance Tuning
2000 WS6 M6 - LS6 (long block, refreshed top end), 10.8:1 CR, 90 mm ported FAST, Exo-Skel, 227/232 cam, QTP HVMC, EWP, GMMG, 9" w/4.11s
2018 Sierra SLT 5.3L A8 - Airaid intake tube, GM Borla catback, L86 Intake/Ported TB
Reply With Quote