So, I acquired a car that was previously tuned with HP tuners to my understanding, I borrowed a buddies MPVI2, connected to the OBD port, and read the existing configuration. I was also able to view the car and sensors inputs through the VCM scanner, so I know I am connected and it's communicating. However, when I view the Editor I see no maps, engine parameters, write functions, etc. Is this because I need to purchase credits? I was under the assumption it was stored in the ECU. I don't know much about HP tuners as I'm an old hondata guy but looking to learn on this project car.
The car runs great when warmed up but runs terrible on a cold start so I am trying to figure out what's going on. Attached is the read file, TIA.