So I got my VE dialed in without the boost--car ran great. I added back everything that I had disabled except for the MAF and created new tune with 2 bar OS. Followed the directions on a video on setting up expanded VE table, spark, PE and Boost Enhancement as suggested. Installed my 2 bar MAP sensor and connected the supercharger (bypassed it during the 1 bar VE tuning).
Did the "Write Entire" as instructed. When I attempted to start the car, it didn't want to start. I finally got it running by holding the throttle open a little but it ran very poorly as if it was extremely rich (smoking also). Put it back to the previous tune (Write Entire again) and it cranked up and ran fine. Went back and looked at the VE table in the 2 bar tune and the lower half was exactly as the original tune which I had copied over. I see the cranking VE tables but they are identical in both the original and 2 bar tune. Did not modify them at all. 2 bar boost tune.hpt What am I missing?
Attached is a copy of the 2 bar tune if I can figure out how to do this.
Thanks
Reply