Well, everyone for shitz and giggles, I decided to monitor the serial port on my computer during a program of a PCM using the programmer that I have.. I found some very good news.. Here is just a little of the log file that I captured...
]Tx 30 00 04 8C FE F0 3F 13 0.....?.
Tx 30 10 0C 6D 10 F0 36 00 0..m..6.
10 00 FF 80 00
F1 8F 02 .......
Rx 31 1
Rx 00 .
Rx 06 .
Rx 6C F0 10 76 00 73 74 l..v.st
The Green portion is the command sent to the programmer to tell it to pass the data along. Then comes the data, which I did not include because this post would have been very large. Next, the yellow is I believe a calculated checksum for the command and data.
Then we have the blue, which is the information from either the tool or the PCM or Both that says everything is okay and send some more data...
there is also some different initization stuff at the very beginning of the program...
Basically, I have figured out how to capture the PCM code directly from the programmer, I now have the command required to write the info to the PCM for this particular programmer.
With information, I can write a Loader program for this programmer and use it to load my PCM and others...
These commands are most likely just for this brand of programmer, but it can be done...
Kevin