min pulse width for SVO injectors?

[2001CamaroGuy]

so what is it? I have looked all over but can't seem to come up with it anywhere. ???

[slow]

what size?

Ryan

[S2H]

you really wont need to change the minimum pulse width...its already wayyyy down there..
you probably need to check your IFR table...

use this worksheet to calculat for new size injectors...
you need to know if its 3 bar or 4 bar...or if they are rated 30# at 40psi or 30#at 43.5 psi...

www.audiohelix.com/hptuners/injectors.xls

[Runn WS7]

I´m running rich at decel (dfco off) with my #42, how much should i lower min inj pulse?

[WS6FirebirdTA00]

I run rich as well, and if I get it to lean out, I get lean spike in and out of the throttle, so I left it rich lol

[EC_Tune]

May want to tickle the 80 Kpa line in the Injector Offset table if you're too rich on decel. Drop it by 10% to start.

HTH
EC

[WS6FirebirdTA00]

I did that on mine, didnt do much really, only thing that worked was the min fuel adjust under transient fuel. I can lower that but then I get lean spikes when I go in and out of hte throttle.

[Runn WS7]

I did that on mine, didnt do much really, only thing that worked was the min fuel adjust under transient fuel. I can lower that but then I get lean spikes when I go in and out of hte throttle.

The 98´s transient fuel is 0.000 from factory.