error message after READ ENTIRE, " This Is an Isuzu vehicle, hahaha, [LOL]"

[2000Firehawk]

JUST KIDDING........

But I did get a 'File Not Supported' "Definition Failed to Load" error message.

This was after I completed a "Read Entire".
I emailed support with the 'read file' + VCM Suite Info.

I must say that the License credit upgrade process is slick & way to cool...
It was an easy & FAST process to get 'credits' via 'paypal' payment.
Copy/pasted the new application key after I updated my VCM SUITE, & I was all good-to-go.

I was even 'prompted' to change my firmware , [MPVI firmware I guess], from 106 to 108 before I could download my stock Isuzu file, when I was starting the "READ ENTIRE" process.

I just hope that I didn't cause the problem by me forgeting something.

Dave

[Bill@HPTuners]

izuzu wasnt supported with the .10 release...if you email keith with the hpt file & info log he should be able to get you setup fairly quickly.

[2000Firehawk]

They had sent me a .11 beta , when I ordered upgrade credits , for the Isuzu.

[Bill@HPTuners]

huh...dunno then...might just be a missing def file...for instance when i had beta 10 i was able to open one I6 TB file but not another...you probably got some of the isuzu def's...just not the one you need...again I would send keith the info I stated & he'll get you setup.

[2000Firehawk]

Ya, it must be something minor, as it read the file fine.
Its just when I was saving it, the error message popped-up.

I did send the file + VCM Suite Info to 'support', for them to figure it out.

That VCM Suite Info function is sweet, all the info for troubleshooting, in a nice compact format.

Dave

[2000Firehawk]

Yea.... it works...

Support sent me a new beta.

Version 2.1.11
VCM Editor
Added - Isuzu Ascender, V8 and I6.
Fixed - Calibration details VIN change for GM L4/I5/I6 vehicles.
Fixed - Rare VCM Write recovery issue for GM 02-05 I6 4.2 vehicles.

Thanks Guys...