How to disable P0011 on 07 Expidition?

[hthy]

Hi,

How to disable P0011 Camshaft position timing over advance (Bank1)?

Thanks

[Sweet35th]

Have you disable VCT, or limited its movement?

[hthy]

I disabled and now i want to disable this code.

Thank you

[Sweet35th]

I disabled and now i want to disable this code.

Thank you

Well first off, make sure under "AIRFLOW" you have Variable Cam disabled. Then under engine calibration, you should be able to scroll to code P0011 and set it to "No Error Reported"

[hthy]

Thanks for reply,

under "AIRFLOW" I don't have Variable Cam disabled.

Thanks again

[Sweet35th]

Thanks for reply,

under "AIRFLOW" I don't have Variable Cam disabled.

Thanks again

Yeah, you will need to set that setting to "disabled" in order to turn the system completely off.

[hthy]

Thanks dear,

Under the airflow no Variable Cam switch.

Thanks

[Sweet35th]

Thanks dear,

Under the airflow no Variable Cam switch.

Thanks

Under the main "ENGINE" menu, under the "AIRFLOW" tab, there should be a sub tab called "VARIABLE CAM" the perameter is under there..

Send me your tune file.

[email protected]

[hthy]

Under the main "ENGINE" menu, under the "AIRFLOW" tab, there should be a sub tab called "VARIABLE CAM" the perameter is under there..

Send me your tune file.

[email protected]

Thank you,
Email sent

[Sweet35th]

I looked at your file, and the parameter is missing from the template. I opened the same calibration in my SCT software, and the switch is there for turning VCT off. So I believe it is a template issue with your calibration from HPtuners. I would contact support on this, or message Eric on the forum.