Results 1 to 4 of 4

Thread: Wideband????

  1. 08-02-2017 #1
    85K5Jake
    85K5Jake is offline
    Tuner
    Join Date
    May 2017
    Posts
    105

    Wideband????

    So I have been looking at getting a wideband, I decided on the AEM 30-0333 with obd2 pass through. I have an 01 lq9 running a P01 ecm and I know the pass through won't work with this setup. My questions are if I wire it through the a/c switch or egr do I have to worry about voltage offset? I have the hptuners standard so no analog interface. I decided on this wideband for future projects that are CAN based. Any thoughts or info would be much appreciated.
    Reply With Quote Reply With Quote
  2. 08-02-2017 #2
    dr.mike
    dr.mike is offline
    Advanced Tuner
    Join Date
    Dec 2005
    Location
    Posts
    604
    If you run the Analog- ( PIN 10 ) wire to the same ground as the A/C sensor's ground, the offset should be nulled out by the built-in offset compensation.
    Reply With Quote Reply With Quote
  3. 08-02-2017 #3
    85K5Jake
    85K5Jake is offline
    Tuner
    Join Date
    May 2017
    Posts
    105
    Thanks for the info dr. mike. Do you think there will be any support for this in non CAN vehicles at some point through hptuners?
    Reply With Quote Reply With Quote
  4. 08-03-2017 #4
    dr.mike
    dr.mike is offline
    Advanced Tuner
    Join Date
    Dec 2005
    Location
    Posts
    604
    Gonna need to hit up the HPT guys for that one.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »